Concrete Roof Tile Calculator

Calculate number of concrete tiles needed by roof area, tile size, overlap, and waste factor for flat, S-profile, and barrel tiles

Quick Estimate

Roof Area?

sqft

Roof Pitch?

:12

Tile Profile?

Tile Width?

Tile Length?

Head Lap?

Waste Factor?

Tiles Needed

1,947

Tiles per Square (100 sqft)79.1

Total Tile Weight (lbs)18,497

Weight per Sq Ft (psf)9.2

Estimated Material Cost$3,894

Link copied to clipboard

Need more accuracy?

Extended mode adds scenarios, charts, and detailed breakdowns

→

How to Use the Concrete Roof Tile Calculator

Accurate material estimates prevent costly over-ordering or mid-project shortages. The Concrete Roof Tile Calculator factors in roof area, pitch, and waste to give you the right quantity to order.

Calculate your total roof area first — use the Roof Area Calculator if needed.
Enter the roof area (in square feet) into the calculator.
Select your material type and the coverage per unit where applicable.
Set the waste factor: 10 % for simple gable roofs, up to 20 % for complex roofs.
The result shows the total quantity plus waste, ready for your order.

Tip: Start with the Quick calculator for a fast estimate. Switch to Extended mode for scenario comparison and charts, or Professional mode for complete parameter control.

Formula & Methodology

The Concrete Roof Tile Calculator uses the following established formulas:

Net Material Needed = Roof Area ÷ Coverage per Unit Order Quantity = Net Needed × (1 + Waste Factor) Waste Factor: 10% simple roof, 15% moderate, 20% complex Roofing Squares = Roof Area ÷ 100

Always round up to the next whole unit (bundle, sheet, roll) when placing your order.

Frequently Asked Questions

How many bundles of shingles do I need per square?

Most standard 3-tab and architectural shingles come 3 bundles per square (100 sq ft). Some heavier designer shingles require 4 bundles per square. Check the bundle coverage on the packaging.

Should I order extra materials?

Yes. Order at least 10 % extra for a simple roof to account for cut waste, starter courses, and ridge caps. For a hip roof or one with multiple valleys, add 15–20 % extra.

Can I return leftover roofing materials?

Many suppliers accept returns of unopened bundles within 30–90 days. Keep your receipts and do not open extra bundles until you are sure you need them. Having a few extras on hand for future repairs is often worthwhile.

Related Calculators

Sources & References

The formulas, code requirements, and reference data used in this calculator are sourced from the following authoritative organizations and publications. Local codes vary — always verify with your jurisdiction's building department.

International Residential Code (IRC) 2024 — Chapter 9: Roof Assemblies — ICC
NRCA Roofing Manual (Steep-Slope & Low-Slope) — National Roofing Contractors Association
Asphalt Shingle Installation Manual — ARMA (Asphalt Roofing Manufacturers Association)
ARMA Asphalt Shingle Coverage Standards — ARMA
Metal Construction Association — Metal Roofing Specifications — MCA
Tile Roofing Industry Alliance Installation Manual — TRI Alliance

Disclaimer: Calculator results are estimates intended for planning and educational purposes only. They do not replace professional engineering analysis, building permit review, or contractor estimates. Always consult a licensed roofing contractor or structural engineer for final specifications.