Gambrel Roof Calculator
Calculate area and dimensions for a gambrel (barn) roof
ft
ft
:12
:12
%
Total Roof Area
2,133 sq ft
Lower Slope Area1,073 sq ft
Upper Slope Area865 sq ft
Roofing Squares21.3 squares
Link copied to clipboard
How to Use the Gambrel Roof Calculator
Using the Gambrel Roof Calculator is straightforward. Gather your building measurements and roof pitch before you start — accurate inputs lead to accurate material estimates.
- Measure the exterior length and width of your building at the foundation.
- Identify your roof pitch (rise per 12 inches of run) — check your building plans or use a pitch gauge.
- Enter both measurements and pitch into the calculator above.
- Review the result: total roof surface area in square feet and roofing squares.
- Add a 10–15 % waste factor when ordering materials for a standard roof, or 15–20 % for complex roofs with many hips and valleys.
Formula & Methodology
The Gambrel Roof Calculator uses the following established formulas:
Roof Area = Footprint Area × Pitch Multiplier
Pitch Multiplier = √(1 + (rise/12)²)
Footprint Area = Length × Width (including overhangs)
1 Roofing Square = 100 sq ft of roof area
The pitch multiplier accounts for the extra surface area created by the slope of the roof.
Frequently Asked Questions
Measure your building's footprint (length × width) from the ground, then multiply by the pitch multiplier for your roof slope. This gives a very accurate surface area without any ladder work. Our Gambrel Roof Calculator does this calculation automatically.
A standard gable roof needs 10 % waste. Add 15 % for moderate complexity (a few hips or valleys) and up to 20 % for highly complex roofs. Always round up to the nearest bundle when ordering shingles.
One roofing square equals 100 square feet of roof surface. Roofing materials — shingles, underlayment, and insulation — are priced and sold per square, so converting your area to squares makes ordering much easier.