Rake Board & Trim Calculator

Calculate linear feet of rake trim needed using pitch multiplier and gable dimensions with overlap allowance

Quick Estimate

Building Width?

Roof Pitch?

:12

Number of Gable Ends?

gables

Board Length?

Board Width?

Rake Length (each side)

16.8

Total Rake Length67.1

Boards Needed5

Estimated Cost ($2.50/lf)$168

Link copied to clipboard

Need more accuracy?

Extended mode adds scenarios, charts, and detailed breakdowns

→

How to Use the Rake Board & Trim Calculator

Trim and component materials are often underestimated. The Rake Board & Trim Calculator accounts for all perimeter lengths, penetrations, and overlap to give you an accurate quantity.

Measure all relevant linear footage: eave length, rake length, ridge length, valley length.
Count and measure any roof penetrations: chimneys, pipes, skylights.
Enter measurements into the calculator.
Review the material list including overlap allowance.
Add 5–10 % for cuts and waste on metal components.

Tip: Start with the Quick calculator for a fast estimate. Switch to Extended mode for scenario comparison and charts, or Professional mode for complete parameter control.

Formula & Methodology

The Rake Board & Trim Calculator uses the following established formulas:

Eave Length = Total horizontal length of all eave edges Rake Length = Total sloped length of all gable edges Ridge Length = Total length of all ridges and hips Valley Length = Total length of all valley intersections

Metal flashing and trim are typically ordered by the linear foot. Always add 10 % for waste and overlaps.

Frequently Asked Questions

What is drip edge and why do I need it?

Drip edge is a metal flashing installed along eaves and rakes to direct water away from the fascia and into the gutter. It prevents wood rot and is required by most building codes for all sloped roofs.

How much flashing do I need around a chimney?

A standard chimney requires base flashing (around the perimeter), step flashing (up the sides), and counter flashing (set into the mortar joints). Total material depends on chimney perimeter — use our Chimney Flashing Calculator for a precise quantity.

What is the difference between a ridge cap and regular shingles?

Ridge cap shingles are pre-bent, thicker shingles designed to fold over the ridge without cracking. They provide a weathertight seal at the highest point of the roof. Using field shingles cut down is cheaper but more labour-intensive and more prone to cracking.

Related Calculators

Sources & References

The formulas, code requirements, and reference data used in this calculator are sourced from the following authoritative organizations and publications. Local codes vary — always verify with your jurisdiction's building department.

International Residential Code (IRC) 2024 — Chapter 9: Roof Assemblies — ICC
NRCA Roofing Manual (Steep-Slope & Low-Slope) — National Roofing Contractors Association
Asphalt Shingle Installation Manual — ARMA (Asphalt Roofing Manufacturers Association)
IRC R905.2.8 — Flashings — ICC
SMACNA Sheet Metal Manual — Flashing & Trim — SMACNA
NRCA Steep-Slope Roofing Details — NRCA

Disclaimer: Calculator results are estimates intended for planning and educational purposes only. They do not replace professional engineering analysis, building permit review, or contractor estimates. Always consult a licensed roofing contractor or structural engineer for final specifications.