Roof Project Cost Estimator

All-in roofing cost: materials + labor + tear-off + decking repair + dumpster + permit + scaffolding + 10% contingency — master cost estimator with cost per sq ft

Quick Estimate

Roof Area (sq ft)?

sq ft

Material Cost per Square ($)?

$/sq

Labor Cost per Square ($)?

$/sq

Tear-Off Layers?

Decking Repair (% of deck)?

Building Permit?

Scaffolding Required?

Material Cost

2,860

Labor Cost1,760

Tear-Off Cost3,300

Decking Repair Cost550

Permit + Dumpster + Scaffolding700

Subtotal (before contingency)9,170

10% Contingency917

Total Estimated Project Cost10,087

Cost per Sq Ft4.59

Link copied to clipboard

Need more accuracy?

Extended mode adds scenarios, charts, and detailed breakdowns

→

How to Use the Roof Project Cost Estimator

Getting an accurate cost estimate before contacting contractors gives you negotiating power and helps you spot outliers. The Roof Project Cost Estimator uses regional averages that you can adjust to your market.

Enter your roof area or building dimensions to establish the project size.
Select your roofing material type and quality tier.
Adjust the labor rate to reflect your local market if needed.
Review the itemised breakdown: materials, labor, tear-off, and disposal.
Use the estimate as a baseline when comparing contractor quotes.

Tip: Start with the Quick calculator for a fast estimate. Switch to Extended mode for scenario comparison and charts, or Professional mode for complete parameter control.

Formula & Methodology

The Roof Project Cost Estimator uses the following established formulas:

Total Cost = (Material Cost/sq + Labor Cost/sq) × Roof Squares Tear-off Cost = Squares × Tear-off Rate/square Disposal Fee = Squares × Disposal Rate/square Contingency = Total × 10% (recommended buffer)

Costs vary significantly by region. Urban markets typically run 20–40 % above the national average.

Frequently Asked Questions

What is the average cost to replace a roof?

A typical asphalt shingle replacement on a 2,000 sq ft home costs $8,000–$15,000 installed in the US (2025). Metal roofing runs $15,000–$30,000 and premium materials like slate or copper can exceed $50,000.

How do I compare roofing quotes?

Ask each contractor for a written, itemised quote showing material brand and grade, labor cost per square, tear-off and disposal, and warranty terms. Compare apples to apples — the same material and coverage.

Is it cheaper to go over the old roof instead of tearing it off?

Re-roofing (laying new shingles over old) saves $1–$3 per sq ft in labor, but most codes allow only two layers maximum. It also traps moisture, adds weight, and voids many shingle warranties. Tear-off is the better long-term choice.

Related Calculators

Sources & References

The formulas, code requirements, and reference data used in this calculator are sourced from the following authoritative organizations and publications. Local codes vary — always verify with your jurisdiction's building department.

International Residential Code (IRC) 2024 — Chapter 9: Roof Assemblies — ICC
NRCA Roofing Manual (Steep-Slope & Low-Slope) — National Roofing Contractors Association
Asphalt Shingle Installation Manual — ARMA (Asphalt Roofing Manufacturers Association)
HomeAdvisor / Angi 2026 Roof Replacement Cost Data — Angi
HomeWyse Roof Cost Guides (regional) — HomeWyse
RSMeans Construction Cost Data — Gordian

Disclaimer: Calculator results are estimates intended for planning and educational purposes only. They do not replace professional engineering analysis, building permit review, or contractor estimates. Always consult a licensed roofing contractor or structural engineer for final specifications.