Skylight Replacement Cost Calculator

Replace existing skylight: removal + new unit + flashing kit + install labor. By size (22×22, 30×46, 44×46) and type (fixed, vented, solar).

Quick Estimate

Skylight Size?

Skylight Type?

Number of Skylights?

Skylight Unit Cost

480

Flashing Kit Cost135

Labor (removal + install)500

Total Cost per Skylight1,115

Total Project Cost1,115

Cost Note

Skylight replacement costs vary by brand and region. Velux and Fakro are the leading manufacturers. Always replace the flashing kit when replacing the skylight — reusing old flashing is the leading cause of post-replacement leaks. Solar-powered venting skylights may qualify for a 30% federal tax credit (IRS Form 5695). Budget an additional $200–$500 if interior trim or drywall repair is needed.

Link copied to clipboard

Need more accuracy?

Extended mode adds scenarios, charts, and detailed breakdowns

→

How to Use the Skylight Replacement Cost Calculator

Getting an accurate cost estimate before contacting contractors gives you negotiating power and helps you spot outliers. The Skylight Replacement Cost Calculator uses regional averages that you can adjust to your market.

Enter your roof area or building dimensions to establish the project size.
Select your roofing material type and quality tier.
Adjust the labor rate to reflect your local market if needed.
Review the itemised breakdown: materials, labor, tear-off, and disposal.
Use the estimate as a baseline when comparing contractor quotes.

Tip: Start with the Quick calculator for a fast estimate. Switch to Extended mode for scenario comparison and charts, or Professional mode for complete parameter control.

Formula & Methodology

The Skylight Replacement Cost Calculator uses the following established formulas:

Total Cost = (Material Cost/sq + Labor Cost/sq) × Roof Squares Tear-off Cost = Squares × Tear-off Rate/square Disposal Fee = Squares × Disposal Rate/square Contingency = Total × 10% (recommended buffer)

Costs vary significantly by region. Urban markets typically run 20–40 % above the national average.

Frequently Asked Questions

What is the average cost to replace a roof?

A typical asphalt shingle replacement on a 2,000 sq ft home costs $8,000–$15,000 installed in the US (2025). Metal roofing runs $15,000–$30,000 and premium materials like slate or copper can exceed $50,000.

How do I compare roofing quotes?

Ask each contractor for a written, itemised quote showing material brand and grade, labor cost per square, tear-off and disposal, and warranty terms. Compare apples to apples — the same material and coverage.

Is it cheaper to go over the old roof instead of tearing it off?

Re-roofing (laying new shingles over old) saves $1–$3 per sq ft in labor, but most codes allow only two layers maximum. It also traps moisture, adds weight, and voids many shingle warranties. Tear-off is the better long-term choice.

Related Calculators

Sources & References

The formulas, code requirements, and reference data used in this calculator are sourced from the following authoritative organizations and publications. Local codes vary — always verify with your jurisdiction's building department.

International Residential Code (IRC) 2024 — Chapter 9: Roof Assemblies — ICC
NRCA Roofing Manual (Steep-Slope & Low-Slope) — National Roofing Contractors Association
Asphalt Shingle Installation Manual — ARMA (Asphalt Roofing Manufacturers Association)
HomeAdvisor / Angi 2026 Roof Replacement Cost Data — Angi
HomeWyse Roof Cost Guides (regional) — HomeWyse
RSMeans Construction Cost Data — Gordian

Disclaimer: Calculator results are estimates intended for planning and educational purposes only. They do not replace professional engineering analysis, building permit review, or contractor estimates. Always consult a licensed roofing contractor or structural engineer for final specifications.